JK Audio AutoHybrid IP2 is fully compatible with sip.audio. It includes Opus, our preferred codec for interoperability. At the time of writing though, Opus is limited to a bitrate of 25kbit/s.

Video: Configure JK Audio AutoHybrid IP2 for use with sip.audio

Add a phone number to your sip.audio account to receive phone calls to this device. 

 Subscribe to hybrIP to screen calls in your web browser.

CONFIGURATION

1. Log in to the web interface for your AutoHybrid unit using its IP address.
2. Under Audio, move Opus to the top of the preferred codec list, with G.722 just below.
3. Under Accounts, configure as follows...
   Account Name: sip.audio
   Username/Number: SIP Username (For example, enter fmstation.autohybrid for fmstation.autohybrid@sip.audio)
   Domain: sip.audio
   Domain Registration: ✓
   Password: SIP Username's Password
4. Under Topology, check the STUN box.
5. Under Advanced, configure as follows...
   Proxy: proxy.sip.audio
   Keep-Alive: ✓ (if behind NAT router)
6. Click Enable, Register, and Restart.
   
7. The Account Status should show Proxy Registered.

CONNECTING

1. Click 'Call Management'.
   Enter destination.account@sip.audio or just destination.account
   
2. Click 'Call'.

CORRECTIONS?

Help to keep the Knowledge Base accurate for the benefit of the worldwide community by contacting In:Quality with details of errors, omissions or updates. Raise a Ticket.